Toro Field Pro 6040 Service Manual page 212

Removing and Installing the Traction Control Linkage (continued)
Chassis: Service and Repairs
3. Remove the fasteners securing the traction control rod to the control lever.
4. Remove the fasteners securing the traction control rod to the piston (traction)
pump and remove the rod from the machine.
5. Continue to remove the traction control lever components as needed.
g415050
1. Traction control rod, LH
6. Verify the length of each traction control rod prior to assembly. The left side
traction control rod should measure 77.1 cm (30.36 inch) and the spring
should be compressed to 11 cm (4.35 inch). The right side traction control
rod should measure 77.3 cm (30.46 inch). .
7. Install any previously removed traction control linkage components.
8. Adjust the traction speed; refer to
Figure 88
Traction Control Rods
2. Traction control rod, RH
Adjusting the Traction Speed (page
Page 7–14
5–41).
Field Pro® 6040
22267SL Rev A