Toro Field Pro 6040 Service Manual page 95

Test Procedure (continued)
Field Pro® 6040
22267SL Rev A
13. Slowly press the traction control lever of the side being tested in the forward
direction until 6,900 kPa (1,000 psi) is displayed on the tester pressure
gauge. Ensure that the wheel being tested is not rotating and record the
flow meter reading. Wheel motor internal leakage is measured by the flow
meter in GPM.
14. Release the traction control lever and set the key switch to the O
15. The flow through a stationary wheel motor should be less than 4.25L/minute
(1.1 GPM). If specifications are not met, repair or replace the worn wheel
motor.
16. Proceed to testing the remaining rear wheel motor if necessary.
17. After testing:
A. Remove the hydraulic tester and hoses then reconnect the hydraulic tube
to the traction pump and to the wheel motor.
B. Install the rear wheel and lower the machine to the ground.
C. Check and adjust the level of the hydraulic fluid in the hydraulic reservoir;
refer to the traction unit Operator's Manual.
D. Start the engine and check for any hydraulic fluid leaks. Repair hydraulic
leaks if necessary before returning the machine to service.
Page 5–29 Hydraulic System: Testing the Hydraulic System
position.
FF