Toro Field Pro 6040 Service Manual page 204

Removing the Front Wheel and Caster Fork
g414444
1. Grease cap
2. Lock nut
3. Belleville washer (3 each)
4. Bearing cone (2 each)
Installing the Front Wheel and Caster Fork
Chassis: Service and Repairs
5. Bearing cup (2 each)
6. Grease seal
7. Lock nut
8. Wheel assembly
1. Raise the front of the machine; refer to
2. Remove the fasteners securing the wheel to the caster fork and remove
the front wheel.
3. Remove the caster fork grease cap.
4. Remove the lock nut from the caster fork spindle and slide the caster fork
from the machine.
5. Remove the three (3) belleville washers and the upper bearing cone.
6. Remove and discard the grease seal, then retrieve the lower bearing cone.
7. Clean and inspect the bearing cups and cones for wear or damage and
replace as necessary.
8. Inspect the wheel assembly for worn or damaged components and repair or
replace then as necessary; refer to
Refer to Figure 81 for this procedure.
1. If previously removed, press new bearing cups all the way into the axle.
2. Pack the bearing cones with No. 2 lithium grease.
Figure 81
10.
Jacking Instructions (page
Servicing the Front Wheels (page
Page 7–6
9. Cap screw
Caster fork
Field Pro® 6040
22267SL Rev A
1–6).
7–7).