Toro Field Pro 6040 Service Manual page 89

Test Procedure
Field Pro® 6040
22267SL Rev A
Special Equipment Required:
•
Pressure Gauge (accurate below 3,500 kPa (500 psi))
•
Hydraulic Tester – Flow meter with pressure gauge that has at least a 57
liters/minute (15 gallons/minute) capacity
•
2 Hydraulic test hoses
•
Non-contact tachometer (photo tach)
1. Read and adhere to the information provided in
(page 5–19).
2. Remove the right rear wheel; refer to
Wheels (page 7–5).
3. Clean the fittings and the hydraulic tube ends at the right side traction pump
"A" port, and at the right side wheel motor "A" port.
g417549
1. Right side wheel motor
2. Hydraulic tube
4. Disconnect both ends of the hydraulic tube and remove the tube from the
machine.
5. Install one hydraulic test hose to the exposed fitting at the traction pump, and
a second test hose to the exposed fitting at the wheel motor.
6. Install a hydraulic tester to the exposed ends of the test hoses. Make sure
the tester is installed in the correct flow direction (toward the wheel bypass
manifold) and the tester flow control valve is fully open.
Removing and Installing the Rear
Figure 27
3. Right side traction pump
Page 5–23 Hydraulic System: Testing the Hydraulic System
Testing the Hydraulic System