Toro Field Pro 6040 Service Manual page 108

Adjusting the Traction Speed (continued)
g404939
1. Upper Jam nut
2. Flats (on control rod)
Hydraulic System: Adjustments
Figure 39
B. Start the engine and set the throttle control to full speed.
C. Move the right hand traction control lever to the full F
D. Use the flats on the control rod to turn the rod in either direction until the
right rear wheel rotates at 160 RPM.
Note: When the traction control lever is moved to the full R
position, the rear wheel should rotate at 80 RPM.
E. Stop the engine and tighten the control rod jam nuts.
F. Loosen the lower jam nut on the left hand control rod.
Note: The lower jam nut has left hand threads.
Page 5–42
3. Right hand control rod
4. Lower Jam nut (left hand threads)
position.
ORWARD
EVERSE
Field Pro® 6040
22267SL Rev A