Toro Field Pro 6040 Service Manual page 146

Installing the Center Lift Cylinder (continued)
Hydraulic System: Service and Repairs
1. Lubricate new O-rings and place them onto the fitting. If previously removed,
install the fittings to the cylinder; refer to
Straight Thread O-Ring Fittings) (page
2. Install the cylinder in the machine with the previously removed components.
3. Remove the caps and plugs from the hydraulic fittings and hydraulic hoses
then install the hydraulic hoses; refer to
(O-Ring Face Seal Fitting) (page
4. Lubricate the grease fittings at each end of the lift cylinder.
5. Charge the hydraulic system;
Installing the Hydraulic Fittings (SAE
5–10).
Installing Hydraulic Hoses and Tubes
5–8).
Charging the Hydraulic System (page
Page 5–80
5–55).
Field Pro® 6040
22267SL Rev A