Advertisement
Angle Cylinder (Optional)
g413856
1.
Elbow fitting (2 each)
2.
Front cylinder pin
Removing the Optional Angle Cylinder
Installing the Optional Angle Cylinder
Field Pro® 6040
22267SL Rev A
Refer to
Figure 61
for this procedure.
1. Park the machine on a level surface, lower the mid-mount attachment to the
ground, set the key switch to the O
the switch.
2. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
3. Clean the area around the hydraulic hose and fitting connections.
4. Disconnect the hydraulic hoses from the angle cylinder. Cap or plug the
disconnected hydraulic hoses and fitting to prevent hydraulic system
contamination.
5. Remove the front and rear cylinder pins and remove the angle cylinder from
the machine.
6. If necessary, record the locations and orientations of the fittings for assembly
purposes then remove the hydraulic fittings from the cylinder.
7. Remove and discard all the O-rings from the hydraulic hoses, and fittings
that were disconnected or removed.
Refer to
Figure 61
for this procedure.
Figure 61
3.
Rear cylinder pin
4.
Angle cylinder
position and remove the key from
FF
Page 5–89
General Precautions for
5–46).
Hydraulic System: Service and Repairs
Advertisement
Chapters
Troubleshooting
