Toro Field Pro 6040 Service Manual page 113

After Repairing or Replacing the Components (continued)
Field Pro® 6040
22267SL Rev A
Fitting) (page 5–8)
O-Ring Fittings) (page
5. Whenever hydraulic fluid has been drained from the pumps (system drain,
flush, or pump removal/installation) it is important to properly prime the
hydraulic pumps, refer to
6. After you disconnect or replace any hydraulic components, operate the
machine functions slowly until the air is out of the system; refer to
the Hydraulic System (page
7. Check for hydraulic-fluid leaks. Shut off the engine and repair leaks if
necessary.
and Installing the Hydraulic Fittings (SAE Straight Thread
5–10).
Priming the Hydraulic System (page
5–55).
Page 5–47
5–54).
Charging
Hydraulic System: Service and Repairs