Front Wheel Motors - Toro Reelmaster 5410 Series Service Manual

Front Wheel Motors

g213688
1. Hydraulic tube
2. O-ring (2 each)
3. 90° hydraulic fitting
4. Square key
5. Brake adapter
6. Bolt (4 each per wheel motor)
Removing the Front Wheel Motor
Hydraulic System: Service and Repairs
7. Left brake assembly
8. Bolt (4 each per brake assembly)
9. Wheel hub
10. Locknut
11. Brake drum
12. Left spring clip
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Block the rear wheels with chocks to prevent the machine from moving.
Figure 157
13.
14.
15.
16.
CAUTION
Releasing Pressure from the
6–8).
Page 6–174
Left wheel motor
Locknut (4 each per wheel motor)
O-ring (2 each)
Hydraulic tube
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C