Toro Field Pro 6040 Service Manual page 111

Adjusting the Traction Speed (continued)
Field Pro® 6040
22267SL Rev A
g404971
1. Set screw
2. Speed setting tool
3. Tab (on control rod plate)
4. Control rod
J. Loosen the fasteners securing the control rod to the adjustment bracket
and control rod plate slightly.
K. Start the engine and set the throttle control to full speed.
L. Move the left hand traction control lever to the full F
M. Turn the speed setting tool knob in either direction until the left rear wheel
rotates at 160 RPM.
Note: When the traction control lever is moved to the full R
position, the rear wheel should rotate at 80 RPM.
N. Release the traction control lever and tighten the fasteners securing the
control rod to the adjustment bracket and control rod plate.
O. Verify the RPM of each rear wheel in the F
and adjust if necessary.
P. Stop the engine and remove the speed setting tool.
9. Test traction control operation before returning the machine to service.
Figure 42
5. Knob
6. Pin
7. Adjustment bracket
Page 5–45
position.
ORWARD
EVERSE
and R
ORWARD EVERSE
Hydraulic System: Adjustments
direction