Toro Field Pro 6040 Service Manual page 209

Installing the Parking Brake Linkage (continued)
Field Pro® 6040
22267SL Rev A
g414697
1. Verify the length of each turnbuckle prior to assembly. Each turnbuckle
should measure 284 to 289 mm (11.2 to 11.4 inch).
2. If previously removed, install the bell cranks and turnbuckles to the wheel
motors.
3. Install the brake shaft, flange bearings, and switch plate. Ensure the brake
shaft depresses the parking brake switch when moved to the fully disengaged
(forward) position.
4. Install each brake link by passing the lower end of the brake link through the
trunion pin in the bellcrank, then secure the brake link to the brake shaft with
the previously removed fasteners.
5. Install the compression spring and flange nut to the bottom of each brake link.
6. Adjust the parking brake linkage; refer to
Linkage (page 7–3).
Figure 85
Turnbuckle Assembly
Adjusting the Parking Brake
Page 7–11 Chassis: Service and Repairs