Towing Or Moving The Machine By Hand - Toro Field Pro 6040 Service Manual

Towing or Moving the Machine By Hand

g406202
1. Hydraulic pump, LH
Hydraulic System: General Information
If towing limits are exceeded, severe damage to the hydraulic pumps
and wheel motors may occur.
If it becomes necessary to tow or move the machine by hand, the traction pumps
must be set to bypass hydraulic fluid. Move the machine at a speed below 4.8
kph (3 mph), and for a very short distance. If the machine needs to be moved
more than 30.5 m (100 ft), the machine should be transported on a trailer.
1. Raise the mid-mount attachment
2. Shut off the engine, remove the key, engage the parking brake, and chock
the wheels.
3. Remove the optional rear attachment.
4. Access the bypass valves from under the rear of the machine.
Do not rotate bypass valves more than 2 turns; this prevents the
valves from falling out of the pump and ensures that hydraulic fluid
does not spill.
5. Use a 5/8 inch wrench to open the bypass valve on the bottom of the hydraulic
pump by turning the valve approximately 2 full turns counterclockwise.
2. Hydraulic pump, RH
6. Open the bypass valve on the remaining hydraulic pump.
7. Disengage the parking brake and move the machine to the desired location.
IMPORTANT
IMPORTANT
Figure 18
Page 5–4
3. Bypass valve (2 each)
Field Pro® 6040
22267SL Rev A