Rip_Sub_Advertise; Routed; Rwhod; Security_Broadcast - Bay Networks 6300 Supplement Manual
Supplement to the remote annex administrator’s guide for unix
Hide thumbs
Also See for 6300:
- Hardware installation manual (138 pages) ,
- Quick start manual (60 pages) ,
- Ordering manual (2 pages)
Table of Contents
Advertisement
Book C
Chapter 2
Configuration Parameters
rip_sub_advertise
This interface parameter controls whether or not the RA 6300 advertises
subnet routes over the SLIP, PPP, and Ethernet interfaces. When enabled,
subnet routes are advertised; when disabled, subnet routes are not
advertised. A Y enables this parameter, an N disables it. The default is Y.
routed
This Annex parameter determines whether or not the RIP routing daemon
is enabled. When enabled, the RA 6300 performs active RIP routing only
if the option_key parameter is set to the correct value. If option_key is
not set correctly, the RA 6300 performs only passive RIP routing when
the daemon is enabled. When disabled, no RIP routing occurs. A Y
enables this parameter, an N disables it. The default is Y.
rwhod
This Annex parameter determines whether or not the RA 6300 listens for
RWHO broadcasts when it builds the host table. A Y enables this
parameter, an N disables it. The default is Y.
security_broadcast
This Annex parameter determines whether or not the RA 6300 broadcasts
for security validation if the preferred security servers are not available.
When enabled, the RA 6300 broadcasts for security; when disabled, the
RA 6300 does not broadcast for security. A Y enables this parameter, an
N disables it. The default is Y.
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-97
Advertisement
Table of Contents
