Bay Networks 6300 Supplement Manual page 48

Chapter 2 Configuring the Remote Annex 6300
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
A-20
4. Execute the show annex all command to review your changes.
Using the example in step 3, the terminal displays:
command: show annex all
Annex Generic Parameters
inet_addr: 132.245.44.187
pref_load_addr: 132.245.44.80
load_broadcast: Y
load_dump_gateway:132.245.44.22
image_name: ""
config_file: "config.annex"
routed: Y
disabled_modules: vci
tftp_dump_name: ""
ip_forward_broadcast: N
option_key: ""
output_ttl: 64
VCLI Parameters
max_vcli: unlimited
vcli_security: Y
vcli_inactivity off
Nameserver Parameters
nameserver_broadcast: N
pref_name1_addr: 192.9.200.95
pref_name2_addr: 192.9.200.85
host_table_size: 64
Security Parameters
enable_security: Y
pref_secure1_host:192.9.200.95
network_turnaround: 2
acp_key: "<unset>"
allow_snmp_sets: N
passwd_limit: 3
max_chap_chall_int: 0
(continued on next page)
subnet_mask:255.255.255.0
pref_dump_addr:132.245.33.8
broadcast_addr:132.245.44.255
load_dump_sequence: net
motd_file: "motd"
authoritative_agent: Y
server_capability: none
tftp_load_dir: ""
ipencap_type: ethernet
tcp_keepalive: 120
session_limit: 1152
cli_prompt: "%a%c"
vcli_password: "<unset>"
rwhod: Y
name_server_1: dns
name_server_2: dns
min_unique_hostnames: Y
security_broadcast: Y
pref_secure2_host: 0.0.0.0
loose_source_route: Y
password: "<set>"
lock_enable: Y
chap_auth_name: "chap"
Book A