Subnet_Mask (Port; Sys_Location; Switch_Type - Bay Networks 6300 Supplement Manual

Supplement to the remote annex administrator’s guide for unix

Hide thumbs Also See for 6300:

Table of Contents

Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX

subnet_mask (port)

This port parameter deﬁnes the subnet mask for an asynchronous SLIP

port or a synchronous PPP interface. Typically, you use this parameter to

divide a network into subnets. Specifying 0.0.0.0, which is the default,

sets the subnet mask to 255.255.255.255, which denotes a non-subnetted

host address.

Setting this parameter incorrectly can cause routing problems.

This Annex parameter supplies LAT host location or identiﬁcation

information. The string size ranges from 0 to 32 characters. The default

is a null string ("").

This PRI line parameter is a string specifying the type of switch provided

by the telephone company for the PRI line. Valid values are AT9 (for the

AT&T 5ESS switch), DMS (for Nortel's DMS100 switch), NI2 (for a

switch supporting National ISDN2), and ETS (for Euro ISDN, NET5

conformance).

The default is

, a blank string. The RA 6300 interprets this as the switch

type appropriate for the line:

For a T1 line, AT9 is used.

For an E1 line, ETS is used.

The switch type parameter is not case-sensitive.

Conﬁguration Parameters