Bay Networks 6300 Supplement Manual page 169

Book A
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
Note the following:
• All of the SPBs define the same number for users to dial into the
RA 6300 (the called number).
• The routing SPBs define different numbers from which the user
can dial in (calling number). Obviously, two users cannot dial in
from the same number at the same time.
Sometimes, the telephone company does not supply
the calling number. In this case, use different called
numbers in the SPBs.
• The Proxy-ARP SBP should not have a subnet defined nor
should there be any static routes defined for the Proxy ARP
interface. Attempting to route through a Proxy-ARP interface
causes packets to be routed improperly or not at all.
Other important issues to note when configuring routing for the RA 6300
are:
• remote_address is not a port parameter; it is a pri b parameter.
To assign remote addresses, you issue the
set pri b command or you define the remote address in the
acp_dialup file. For detailed information, see remote_address
on page C-92.
• You do not need to reboot the RA 6300 to activate a parameter
change for en0. Instead, issue the admin or na command reset
interface en0.
Chapter 9 Routing Information Protocol (RIP)
A-141