Reset_Idle_Time_On; Retrans_Limit; Rip_Accept; Table C-28. Valid Options For The Rip_Accept Parameter - Bay Networks 6300 Supplement Manual

Book C
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX

reset_idle_time_on

This asynchronous port parameter defines whether input or output resets
the idle timer. The idle time is the time lapse between activity and
inactivity at the device. This parameter is used with the who command.
Valid options are input and output. The default is input.

retrans_limit

This Annex parameter defines the number of times an RA 6300
retransmits a packet before notifying the LAT user about a network
failure. Allowable values range from 4 to 120. The default value is 8.

rip_accept

This interface parameter defines the networks for which the RA 6300
accepts advertised routes.
is all.

Table C-28. Valid Options for the rip_accept Parameter

Option Description
access_spec Uses the form [include | exclude] network_list where
include means accept RIP updates only for the networks in
network_list, and exclude means accept all RIP updates
except for those in network_list. You can list up to eight
network IP addresses in network_list.
none No RIP updates are accepted over the interface.
all RIP updates for all networks are accepted.
Chapter 2
Table C-28 lists the valid options; the default
Configuration Parameters
C-93