Book C
Chapter 2
Configuration Parameters
printer_name
This asynchronous port parameter specifies the printer used by the tn3270
command's print-screen function. You must enter a name listed in the
/etc/printcap file on the remote host by the printer_host parameter .
prompt
This asynchronous port parameter defines a port-specific prompt string.
The prompt string consists of displayable characters and embedded
formatting codes. Each formatting code, which consists of a percent
character (%) followed by a single character, is compressed and stored
as a single character in non-volatile memory. The maximum number of
characters stored for the prompt string is 16. Since each formatting code
consists of two characters, the maximum string size is 32 characters.
String sizes smaller than 32 characters are rejected as bad values if they
cannot be stored into 16 characters in non-volatile memory after the
formatting codes are compressed into single characters. Table C-20 on
page C-48 lists and describes these codes. The RA 6300 parameter
cli_prompt defines the default prompt.
redisplay_line
This asynchronous port parameter defines the reprint line character for
CLI users. The allowable value is a control character sequence. The
default is
.
CTRL-R (^R)
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-91