Load_Dump_Gateway; Load_Dump_Sequence; Local_Address; Table C-24. Valid Options For The Load_Dump_Sequence Parameter - Bay Networks 6300 Supplement Manual

Chapter 2 Configuration Parameters
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-68

load_dump_gateway

This Annex parameter specifies the gateway's IP address. A gateway is
required if the preferred load or dump host is on a different network or
subnet than the RA 6300. The default is 0.0.0.0 (no gateway).

load_dump_sequence

This Annex parameter specifies available network interfaces (Ethernet or
self) and the order in which they are used for a down-line load or an up-
line dump. You can list more than one interface by using commas to
separate interface names.

Table C-24. Valid Options for the load_dump_sequence Parameter

Option Description
net For use with a local area network. This is the default value.
self Instructs the RA 6300 to boot its image from the Flash ROMs. Since
the RA 6300 cannot dump back to itself, when booting via self,
always have a secondary load/dump interface by setting
load_dump_sequence to self,net.

local_address

This asynchronous/synchronous global port parameter defines the IP
address for the asy, ta, or syn port on the RA 6300 side of a link. This IP
address is used only when the mode parameter is set to slip or ppp. The
default is 0.0.0.0.
Table C-24 describes the valid options.
Book C