Bay Networks 6300 Supplement Manual page 123
Supplement to the remote annex administrator’s guide for unix
Hide thumbs
Also See for 6300:
- Hardware installation manual (138 pages) ,
- Quick start manual (60 pages) ,
- Ordering manual (2 pages)
Table of Contents
Advertisement
Book A
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
2.
Specify the RA 6300 on which you intend to change global port
parameter settings at the COMMAND: prompt. Specify the
administrative password for host at the password: prompt.
You can specify the RA 6300 by its IP addresses or name. If you
intend to change global port parameter settings on more than one
RA 6300, separate their IP addresses or names using a comma (,). If
prompted for a password, the password is the administrative
password for the RA 6300..
For example:
COMMAND:annex 132.245.6.40 or
annex 132.245.6.40,132.245.6.45
password:
3.
Specify a new setting for the global port parameter at the
COMMAND: prompt.
For example, to change the default setting of the address_origin
parameter (local) to enable IP addressing through the acp_dialup
file, enter the following:
COMMAND:set port address_origin acp
The new parameter setting is stored automatically in non-
volatile RAM.
4.
To review your changes, issue the show port all command at the
COMMAND: prompt.
This command displays all of the global port parameter settings. To
locate the parameters you changed, press the Return key (only is
pager is set), which allows you to scroll down through the file.
COMMAND: show port all
5.
Enter quit at the COMMAND: prompt to exit na.
COMMAND: quit
Chapter 6
Point-to-Point Protocol (PPP)
A-95
Advertisement
Table of Contents
