Bay Networks 6300 Supplement Manual page 95

Book A
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
Table A-6. SPB Field Definitions (continued)
Field Definition
called_no Typically, you use this number to distinguish the
(continued) services required for different types of calls. For
example, you can have modem users dial into one
number, V.120 users dial into another number, and
synchronous PPP users dial into a third number. (You
would put each number in its own SPB.)
Note: The ACP log file shows the called number
delivered by the switch, which may only contain the
final digits of the number.
If this field is omitted, any called number will match
this SPB.
called_subaddress (Optional) This field is appropriate only for end-to-end
ISDN calls using a PRI line that the telephone
company has provisioned for subaddressing.
bearer (Optional) Specifies the bearer capability of the call.
Valid values are voice and data.
call_action (Mandatory) Defines how to handle the call. Valid
values:
reject, which rejects the call.
modem, which handles the call as a modem call.
v120, which handles the call as a V.120 call.
sync, which handles the call as a synchronous PPP call.
max_number_of_ (Optional) Defines the maximum number of calls that
calls this session handles simultaneously. Valid values are
integers from 1–23 (in the U.S.) and 1–30 (in Europe).
If this field is omitted, the default is the upper limit (23
or 30).
acp_log (Optional) Specifies whether or not the RA 6300
forwards a call's SETUP information elements and
status to the ACP log file. Valid values are yes and no
(the default). Status is logged as call accept, call reject,
or call disc (disconnect).
(continued on next page)
Chapter 3 Configuring the PRI Interface, Global Ports,
A-67