Bay Networks 6300 Supplement Manual page 215

Book A
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
default_zone_list
This zone list is sent to ARA clients as the local back-up to ACP. The
parameter is a 100-character string with spaces separating the zones, e.g.,
marketing engineering sales. When this parameter is not set, the
RA 6300 provides the network zone list. The default is a null string ("").
You must use the backslash (\) character to escape embedded spaces.
node_id
This is the address the RA 6300 tries to acquire at start-up. If this address
is in use, the RA 6300 must acquire a new node ID. The node_id is an
AppleTalk address in the form net.node. Valid net values are 0 to 65534;
valid node values are 0 to 254. The default is 0.0.
option_key
The option_key parameter enables the AppleTalk-specific RA 6300
parameters as well as the ARA protocol. AppleTalk commands,
parameters, and port functions are enabled only after the correct key is
set; after setting the key, the administrator must reboot the RA 6300. Each
RA 6300 requires a unique key value. The way to obtain a key depends
on the configuration and type of RA 6300 you purchased. Some option
key values are physically attached to the bottom of the RA 6300. If the
number is there, use it. If not, contact your supplier to obtain an
option_key value.
The option_key parameter enables a variety of RA 6300 features,
including tn3270, AppleTalk, and IPX. When requesting an
AppleTalk option_key value from your supplier, be sure to mention
any of the other option_key features currently enabled for your
RA 6300.
Chapter 12 AppleTalk
A-187