Chapter 2
Configuration Parameters
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-40
allow_broadcast
This asynchronous port parameter allows an asynchronous port to receive
administrative broadcast messages generated by the boot and broadcast
commands. A Y enables this parameter, an N disables it. The default is Y.
allow_compression
This asynchronous/synchronous port parameter allows the RA 6300 to
use TCP header compression on a SLIP or PPP line. Header compression
occurs only if the other side of the serial link initiates compression. A Y
enables this parameter, an N disables it. The default is N.
analog_encoding
This PRI line parameter specifies the encoding type used for modem calls.
Valid values are:
•
a_law (used for E1/PRI lines in Europe)
•
mu_law (used for T1/PRI in the U.S.)
•
auto (the default, which uses a_law or mu_law as appropriate)
Typically, you do not need to change this parameter. To check that the
correct value is being used, issue the pri command from the superuser
CLI.
allow_snmp_sets
This Annex parameter enables the RA 6300 to accept and process SNMP
set commands. When disabled, the RA 6300 rejects all SNMP set
commands; the RA 6300 SNMP agent returns the error no such name for
the first object in the set command. A Y enables this parameter, an N
disables it. The default is N.
Book C