Bay Networks 6300 Supplement Manual page 50

Chapter 2 Configuring the Remote Annex 6300
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
A-22
TMux Parameters
tmux_enable: N
tmux_delay: 20
DHCP Parameters
pref_dhcp1_host: 0.0.0.0
dhcp_bcast: N
5. Execute either boot or reset annex all to effect these changes at
the Annex.
You can configure more than one RA 6300 simultaneously using one of
these sequences:
• Define the RA 6300 using the annex command. Next, use the
set annex command to change the parameters.
• Define the parameters for one RA 6300 and use the write
command to copy the parameters to a script file. The script file
will contain all copied parameter settings with a comment
character (#) at the beginning of lines defining the settings for
the Internet address, administrative password, virtual CLI
password, LAT key, option key, and ACP key. Remove the
comment character for any of these settings you want to use.
• Next, execute the read command for all RA 6300s you want to
configure.
tmux_max_host: 64
tmux_max_mpx: 700
pref_dhcp2_host: 0.0.0.0
Book A