Parameter Descriptions - Bay Networks 6300 Supplement Manual

Book C
Setting All Parameters

Parameter Descriptions

Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
To set all of the RA 6300's parameters to the supplied defaults, use the
ROM monitor erase command (see the appropriate Annex Hardware
Installation Guide). This command erases all parameters, including the
RA 6300's IP address. After issuing erase, you must re-enter the
RA 6300's IP address and re-configure the RA 6300.
The RA 6300 configuration parameters are grouped by type, e.g., Annex,
interface, etc. Parameters within these groups are further divided by
relative function. Each function has an associated keyword (e.g.,
nameserver, security, time, etc.). The set and show commands accept
these keywords as arguments.
• Table C-14 lists the keywords and the associated parameters that
display with the show annex command.
• Table C-15 lists the keywords and the associated parameters that
display with the show interface command.
• Table C-16 lists the keywords and the associated parameters that
display with the show port command.
• Table C-17 lists the keywords and associated parameters that are
displayed by the show pri command.
• Table C-18 lists the keywords and associated parameters listed
with the pri show b command.
In this chapter, Annex parameters are those parameters that you set
or show via the set annex or show annex command. RA 6300
parameters are all of the configuration parameters, including Annex,
interface, port, and pri parameters.
The LAT-related parameters are visible only when the lat_key
parameter contains the correct key value (for more details, see
lat_key on page 2-66 ).
Chapter 2 Configuration Parameters
C-33