Bay Networks 6300 Supplement Manual page 120

Chapter 6 Point-to-Point Protocol (PPP)
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
A-92
2. Go to the pri section in the file. The section begins with the
percent symbol (%) and the name pri. Do the following:
• Read the information that precedes each default SPB
provided in the configuration file. You should be familiar with
this information before you enable or disable a default SPB.
• Remove the comment character (#) from the beginning of
each line of each SPB you want to enable.
• Enter a comment character (#) at the beginning of each line
of each SPB you want to disable.
• Following the called_number field in an SPB that has one,
replace the string with the telephone number callers will use
from remote nodes that will use this SPB. For example, to
enable the default SPB that handles PPP calls, do the
following:
#begin_session sync
#
called_no Replace_this_string_with_your_SYNC_PPP_telephone_number
#
#call_action sync
#set mode ppp
#end_session
Remove the
comment character (#)
from the beginning
of each line.
3. Save the file.
4. Issue a reset annex session command from na or admin.
Book A
Replace this string with the
telephone number callers
using SYNC PPP will use.