Tmux_Enable; Tmux_Max_Host; Tmux_Max_Mpx; Toggle_Output - Bay Networks 6300 Supplement Manual

Book C Chapter 2 Configuration Parameters

tmux_enable

This Annex parameter controls whether or not an RA 6300 uses TMux
to multiplex small TCP packets into a single IP packet. This parameter
works only if the host supports TMux. When enabled, and the host does
not support TMux, the RA 6300 will not support multiplexing. A Y
enables this parameter, an N disables it. The default is N.

tmux_max_host

This Annex parameter specifies the maximum number of host addresses
allowed in the TMux address table. If the number of host addresses
exceeds the value entered here, the RA 6300 discards the oldest entry.
Allowable values are 10 through 255; the default is 64.

tmux_max_mpx

This Annex parameter specifies the largest user packet that can be placed
in a TMux packet. The RA 6300 does not multiplex larger packets, but
passes them directly to the IP layer. Allowable values are 5 through 65535;
the default is 700.

toggle_output

This asynchronous port parameter defines the character that flushes the
output buffer for CLI users. The flush character must be a ,
CTRL- X (^ X )
where represents an alphanumeric value (not case sensitive). Pressing
X
this character flushes the output buffer. The default is .
CTRL-O (^O)
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-107