Bay Networks 6300 Supplement Manual page 189

Book A
Remove the
comment character (#)
from the beginning
of each line.
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
2. Go to the pri section in the file. The section begins with the
percent symbol (%) and the name pri. Do the following:
Read the information that precedes each default SPB provided in the
configuration file. You should be familiar with this information before
you enable or disable a default SPB.
Remove the comment character (#) from the beginning of each line
of each SPB you want to enable.
Enter a comment character (#) at the beginning of each line of each
SPB you want to disable.
Following the called_number field in an SPB that has one, replace
the string with the telephone number callers will use from remote
nodes that will use this SPB.
For example, to enable the default SPB that handles synchronous
IPX over PPP calls, do the following:
#begin_session sync
#called_no Replace_this_string_with_your_SYNC_PPP_telephone_number
#
#call_action sync
#set mode ppp
#end_session
To handle IPX/PPP asynchronous modem calls, create the following
SPB in the %pri section of the configuration file:
begin_session ipxcp_modem
called_no Replace_this_string_with_your_IPXCP_telephone_number
call_action modem
set mode ppp
end_session
3. Save the file.
4. Issue a reset annex session command from na or admin.
Chapter 11 Internetwork Packet Exchange (IPX) Protocol
Replace this string with the
telephone number callers
using sync IPX over PPP
will use.
Replace this string with the
telephone number callers
using async IPX over PPP
will use.
A-161