Bay Networks 6300 Supplement Manual page 96

Chapter 3 Configuring the PRI Interface, Global Ports, and Sessions
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
A-68
Table A-6. SPB Field Definitions (continued)
Field Definition
rate56k (Optional) If set to yes, specifies a data rate of 56 kilobytes
for the B channel, even if the bearer information in the
incoming ISDN SETUP message indicates a different rate.
The default is no, which sets the data rate to the rate
provided in the SETUP message. Do not change this default
unless you are in Europe or Australia and are having
problems receiving calls from the U.S. In this situation, the
phone company sometimes fails to specify the correct data
rate. In all other situations, use the default setting of no.
set (Optional) Specifies a port parameter setting that will be
applied to the session. The syntax is:
set [parameter parameter_value]
You can specify multiple set commands. These settings will
override the values in non-volatile memory while the
session is active, but they will not change the actual values
in non-volatile memory. Any parameters not specified in the
set field are determined by the actual global (non-volatile
memory) settings.
Keeping the SPB format and field definitions in mind, perform the
following steps to configure SPBs:
1. Log into the load host and open the Annex configuration file.
The configuration file is located in the install directory on the load
host (the default file is /usr/annex/config.annex). Use any system
editor (e.g., vi, textedit) to open the file. For example, enter:
cd /usr/annex
vi config.annex
Book A