Bay Networks 6300 Supplement Manual page 268

Chapter 15 Using RA 6300 Security
Time
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
A-240
The time criterion lets you control security based on the day of the week,
the date, and the time of day. The following are the four possible syntaxes:
time=" day "
time=" time1 – time2 day1 – day2 "
time=" time1 day1 – time2 day2 "
time=" time1 date1 – time2 date2 "
Enclose the time criterion in quotation marks and specify the arguments
as follows:
• For day, specify a weekday, e.g., Sunday or Monday. The time
criterion will apply to that entire day. Weekday specifications
observe minimum uniqueness and are not case sensitive.
• For time1, specify the beginning of a time range; for
specify the end of a time range. Use hh:mm[am|pm], where hh
is the hour and mm is the minutes, as the format for each end of
the range. If you do not include am or pm, the Remote Annex
assumes you are using military (24-hour) notation. Both ends of
a range must use the same type of notation – you cannot use
military time for one part of a range and am or pm for the other.
To indicate midnight, specify either 12:00am or 00:0. Specify
noon as 12:00pm or 12:00. To indicate a 24-hour range, use
either 00:00 – 23:59 or 12:00am – 11:59pm.
Be sure to include the colon and minutes (:mm) after the hour
(hh). For example, 9:00am – 5:00pm is valid; 9am – 5pm is not.
Book A
,
time2