Bay Networks 6300 Supplement Manual page 156

Chapter 7 Serial Line Internet Protocol (SLIP)
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
A-128
To enable this configuration:
1. Edit the configuration file to add the IP address of the Remote
Annex.
For more details, see Dynamic Allocation of Network Addresses on
page A-274.
2. Edit the configuration file to define an SPB.
You can use the default SPBs provided as part of the config.annex
file or create them specifically for your requirements. For more
details, see Step 2: Edit the Annex Configuration File
3. Review the global port parameter settings, then, if required,
reset these parameter settings.
• Set the subnet_mask parameter to 255.255.255.0.
• Set the cli_security parameter to Y to enable this function.
• Enabling cli_security implements user authentication by the
host-based ACP server for all CLI connections.
• Use the supplied defaults for the data_bits (8), stop_bits (1),
and parity (none) parameters.
SLIP is an 8-bit protocol. If data_bits is set to 7, and
parity is not set to none, the RA 6300 forces the
data_bits setting to 8 and the parity setting to none.
Otherwise, the RA 6300 generates an error message for
the port.
• Set the allow_compression parameter to Y if you want the
RA 6300 to accept compressed packets.
• Set the local_address parameter to the RA 6300 en0 address.
• Set the address_origin parameter to acp.
Book A
on page 7-118.