Session_Limit; Short_Break; Slip_Mtu_Size; Slip_No_Icmp - Bay Networks 6300 Supplement Manual

Book C Chapter 2 Configuration Parameters

session_limit

This Annex parameter specifies the maximum number of active sessions
the RA 6300 allows at one time. Allowable values range from 1 to 1152
or none (entering none sets the value to 1152). The default is 1152.
short _ break
This asynchronous port parameter allows an RA 6300 to return a user to
the CLI prompt after receiving a break of less than two seconds. This
occurs only at the CLI level. A Y enables this parameter, an N disables
it. The default is Y.

slip_mtu_size

This asynchronous port parameter sets the maximum transmission unit
(MTU) size on a SLIP/CSLIP port. This parameter forces the SLIP
interface to use large (1006) or small (256) MTUs. The default is small.

slip_no_icmp

This asynchronous port parameter controls whether or not the RA 6300
discards any ICMP packets directed to the SLIP link. When enabled, the
RA 6300 reduces unnecessary traffic and messages over the SLIP link.
A Y enables this parameter, an N disables it. The default is N.
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-99