Chapter 2
Configuration Parameters
Book C
To set an inactivity timer of 30 seconds, set:
net_inactivity_units=seconds
net_inactivity=30
An inactivity timer can be set to the following combinations:
0 to 4 minutes 15 seconds (= 255 seconds) in 1 second intervals
0 to 4 hours 15 minutes (= 255 minutes) in 1 minute intervals
network_turnaround
This Annex parameter defines the approximate number of seconds that
an RA 6300 waits for a response from a security server (an algorithm
defines the actual time which typically is longer than the defined value).
This parameter works only when the enable_security parameter is set to
Y. Allowable values range from 1 to 255. The default is 2.
Setting this parameter to a high number is not recommended unless a
large timeout value is required for contacting (for security) slow hosts or
waiting for a slow host's response to a security request.
newline_terminal
This asynchronous port parameter interprets carriage returns and line
feeds at the CLI level. When enabled, a line feed terminates both the input
and the output lines. When disabled, a carriage return or a line feed
terminates the input line and a carriage return followed by a line feed
terminates output lines. A Y enables this parameter, an N disables it. The
default is N.
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-78