Setting Parameters To Supplied Defaults - Bay Networks 6300 Supplement Manual

Book C
Setting Annex
Parameters
Setting interface
Parameters
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX

Setting Parameters to Supplied Defaults

Each configuration parameter, except the RA 6300's IP address, has a
default value. Using the na command set, you can return any parameter
to its default setting (for more details, see set on page C-20). Depending
on the parameter type, the syntax options are:
1. set annex annex_parameter 0
The set annex annex_parameter 0 command sets parameters that
require a numeric value. For example, to set pref _ dump _ addr to its
default, 0.0.0.0, enter:
command: set annex pref_dump_addr 0
2. set annex annex_parameter ""
The set annex annex_parameter "" command sets all parameters
that require a string value; these parameters default to either a null
string ("") or "<unset>". For example, to set image _ name to its
default, a null string (""), enter:
command: set annex image_name ""
set annex annex_parameter default
3.
The set annex annex_parameter default command sets all other
parameters. These parameters are set by choosing either an option
from a known list or a yes/no response. For example, to set
enable_security to its default, N, enter:
command: set annex enable_security default
To set an interface parameter to its default value, use the set interface
command:
1. set interface interface_parameter ^@
2. set interface interface_parameter " "
3. set interface interface_parameter default
Chapter 2 Configuration Parameters
C-31