Bay Networks 6300 Supplement Manual page 147

Book A
Remove the
comment character (#)
from the beginning
of each line.
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
To edit the configuration file:
The following instructions describe how to enable and disable the
default SPBs that exist within the configuration file. These default
SPBs will handle modem, V.120, and synchronous PPP calls made to
the RA 6300.
1. Open the configuration file.
The configuration file is located in the install directory on the UNIX
load host (default filename is /usr/annex/config.annex).
Use any system editor (e.g., vi, textedit) to edit the file.
2. Go to the pri section in the file. The section begins with the
percent symbol (%) and the name pri. Do the following:
• Read the information that precedes each default SPB
provided in the configuration file. You should be familiar with
this information before you enable or disable a default SPB.
• Remove the comment character (#) from the beginning of
each line of each SPB you want to enable.
• Enter a comment character (#) at the beginning of each line
of each SPB you want to disable.
• Following the called_number field in an SPB that has one,
replace the string with the telephone number callers will use
from remote nodes that will use this SPB.
For example, to modify a default SPB that handles SLIP calls
over V.120, do the following:
#begin_session v120
#called_no Replace_this_string_with_your_V.120/SLIP_telephone_number
#bearer data
#
#call_action V.120
#set mode auto_detect
#end_session
Chapter 7
Change the mode
from auto_detect
to slip. .
Serial Line Internet Protocol (SLIP)
Replace this string with the
telephone number callers
using SLIP over V.120
will use.
A-119