Bay Networks 6300 Supplement Manual page 568

Chapter 3 Using the CLI Commands
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-112
synn (where n is an integer specifying the number of an internal
synchronous port.)
tan (where n is an integer specifying the number of an internal
TA (V.120) port.
• The primgr process applies only to the RA 6300. This process
handles ISDN signaling.
• Ignore the following statement in the descriptions of the cp,
more, mv, and rm commands:
Only ROM revisions 0600 and greater with the self boot option
installed support this command.
• The modem command description is incorrect for the RA 6300
when it states that the Annex supports only modem types
defined in the Annex configuration file. RA 6300 modem types
are hard-coded.
Also, the RA 6300 supports two additional arguments to the
modem command: –m and –u. For more information, see
Modems on page A-81.
• The pri superuser CLI command is available for use with the
RA 6300. This command displays PRI information. Issued with
the b argument, the pri command displays information about the
PRI B channel assignments. For a complete description of pri
and pri b, see Network Administration on page B-1.
• The superuser CLI sessions command is available for use with
the RA 6300. This command displays information about active
Session Parameter Blocks (SPBs). For a description, see
Displaying Active Session Parameter Blocks on page B-7.
• The stty isize parameter does not apply to the RA 6300 (even
though the parameter is still available).
Book C