Bay Networks 6300 Supplement Manual page 151

Supplement to the remote annex administrator’s guide for unix

Hide thumbs Also See for 6300:

Table of Contents

Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX

Assigning IP Addresses to PRI B Channels

Use the set pri b command (issued with the remote_address global port

parameter) associates IP addresses with PRI B channels. This lets you

conﬁgure ﬁxed IP addressing for RA 6300 sessions. You can use na or

admin to use this command.

Command Syntax

Use the following command syntax when creating B channel IP address

assignments:

set pri b=< ch-range > remote_address < ip-addr > [< increment >]

<ch-range> is a single B channel number or the entire set of B channels

speciﬁed by a range.

<ip-addr> is the IP address you want to assign to a single B channel or

the ﬁrst channel of the entire set.

<increment> is the value (number) by which you want to increment

automatic IP address assignment to B channels in a range or list after the

ﬁrst assignment.

You can associate IP addresses with PRI B channels:

For a single B channel (e.g., 4).

For the entire set of PRI B channels by:

Specifying channels as a range of two numbers separated by a

dash (1-23 for T1; 1-30 for E-1).

Using the keyword all.

Serial Line Internet Protocol (SLIP)