Bay Networks 6300 Supplement Manual page 132
Supplement to the remote annex administrator’s guide for unix
Hide thumbs
Also See for 6300:
- Hardware installation manual (138 pages) ,
- Quick start manual (60 pages) ,
- Ordering manual (2 pages)
Table of Contents
Advertisement
Chapter 6
Point-to-Point Protocol (PPP)
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
A-104
2.
Edit the Annex configuration file to define an SPB.
You can use the default SPBs provided as part of the Annex
configuration file or create them specifically for your requirements.
For more details, see
page 6-91.
3.
Reset default global port parameters to the following settings as
required:
•
Use the defaults for the data_bits (8), stop_bits (1), and
parity (none) parameters.
PPP is an 8-bit protocol. If data_bits is set to 7, and parity
is not set to none, the RA 6300 forces the data_bits
setting to 8 and the parity setting to none. Otherwise, the
RA 6300 syslogs an error message for the port.
•
Set the address_origin parameter to local.
•
Set the local_address parameter to 122.245.10.7.
•
Set the subnet_mask parameter to 255.255.255.0.
•
Set the metric parameter to one.
•
Set the ppp_username_remote parameter to the string "".
•
Set the ppp_password_remote parameter to the string "".
•
Set the slip_ppp_security parameter to Y.
•
Set the ppp_security_protocol parameter to pap (password
authentication protocol).
Setting ppp_security_protocol parameter to pap
assumes that the Marlin router is configured to use PAP.
•
Set the allow_compression parameter to Y if you want the
RA 6300 to accept compressed packets.
Step 2: Edit the Annex Configuration File
Book A
on
Advertisement
Table of Contents
