Correcting Remote Annex 6300 Parameters; Table 4-8. Errors From Last Open Request - Bay Networks 6300 Hardware Installation Manual

Remote annex
Hide thumbs Also See for 6300:
Table of Contents

Advertisement

Table 4-8. Errors from Last Open Request

Error
Description
ARP errors
Address Resolution Protocol (ARP) errors indicate
that the Remote Annex 6300 is configured to boot
from a specified host, but the host would not transmit
its Ethernet address to the Remote Annex 6300.
Possibly, the Remote Annex 6300 configuration
includes the wrong IP encapsulation.
ERPC layer
See
errors
Aborts rx'd
The host's BFS transmitted an abort in response to the
Remote Annex 6300's Open Request. This often
means that the requested file does not exist on that
server. Run erpcd –D on the host to obtain more
information.

Correcting Remote Annex 6300 Parameters

The following parameters must accurately reflect both the Remote
Annex 6300 and the network environment in which it operates.
Verify the Remote Annex 6300's IP address using the addr command.
If your network configuration does not support the factory defaults,
verify the following parameters using the addr command:
The broadcast address.
The subnet mask.
The load/dump gateway address (which must be specified
if the preferred load server host is located on another
network or subnet).
Remote Annex 6300 Hardware Installation Guide
Chapter 4
Table
4-6.
Troubleshooting Procedures
4-13

Advertisement

Table of Contents
loading

Table of Contents