Twister II Power/Fuse Assembly
The Power Entry Port/Fuse assembly is located on the side of one
pod. There is always only one power entry port for the Twister II,
regardless of the number of pods. Additional pods do not have
power connectors.
Component
Communication
Port
Power Cable Port
Fuse Cover
Optional Components
Additional pods and racks are available from Caliper for use with
the Twister II robot. Contact Caliper Sales for more information.
P/N 113564 Rev. 2
Communication
Port
Figure 78. Power/Fuse Assembly
Description
9-pin communication cable port. The
communication cable attaches to a comm port
on the computer.
Connector for the power cable.
WARNING
Appliance inlet is disconnecting device. Place
device or equipment in a manner so that
disconnecting device is accessible all the time.
The fuse housing assembly. The fuse
configuration must match the power supply,
either 100/120V or 240V. If it does not match,
you must change the fuse configuration. See
"Changing the Twister II Fuse(s)" on page
Twister II Robot User's Manual
Twister II Hardware
Power cable
Fuse Cover
Port
Caliper Life Sciences, Inc.
98
105.