Table of Contents
Advertisement
Field
+/-
S/D
Rack
Material
Name
Quantity
Source/
Destination
Tip Base
Height
OK
Cancel
P/N 113564 Rev. 2
Description
Buttons to add or remove a material from the rack
above the buttons. Click "+" to add one material to
the rack or click "-" to remove one material from
the rack. (Only for use during error recovery.)
Buttons to define a rack as a Source or
Destination rack. Changes the Source/Destination
field, as appropriate. (Only for use during error
recovery.)
The rack number that the data in the row applies
to.
The name of the material that is in the rack, as
defined in the CLARA application.
The number of materials that are in the rack.
The type of rack: Source or Destination.
• Source - A rack that the robot is taking
materials from.
• Destination - A rack that the robot is moving
materials to.
This setting is determined by the CLARA
application.
The height of the tip box base in millimeters, as
specified in the Capacity Planning window.
Saves any changes made to the material
positions. If you make changes during a CLARA
run, the following error window opens.
Click Yes to save changes. Note that making
changes to the material positions during a run can
cause the robot to crash, which may spill plates or
damage the robot.
Click No to display the changes on the window
without saving them. The window will update with
the actual material positions the next time a plate
is moved in the racks.
Closes the Runtime Stack Storage
Configuration window.
Twister II Robot User's Manual
Appendix A: Software Reference 169
Caliper Life Sciences, Inc.
Advertisement
Table of Contents
