Plate Location Window
Use the Plate Location window to specify which instrument
position you want the robot to get a plate from or put a plate into. To
open the Plate Location window, click the Get Plate or Put Plate
button on the Test and Verify tab (see
Plate Location - The Instrument position number that you want the
robot to get a plate from or put a plate into. Only specify position
numbers that have already been taught.
OK - Moves the robot through all required positions and paths to
retrieve a material from or place a material into the selected
material position.
WARNING
The robot moves from its current position directly to the selected
instrument's Safe position in one direct motion. Make sure there is a
clear path to the instrument's Safe position before clicking OK to
prevent a robot crash or spilling of material contents.
Cancel - Closes the Plate Location window without moving the
robot.
P/N 113564 Rev. 2
Figure 107. Plate Location Window
Twister II Robot User's Manual
Appendix A: Software Reference 134
page
128).
Caliper Life Sciences, Inc.