Table of Contents
Advertisement
Setting up a Storage Configuration (Continued)
16 Repeat this process for other methods, if other methods are to
Your storage configurations are now compiled, and you are ready
for system operation.
iLink PRO Storage Setup
This section is for systems using a Twister II robot with the iLink
PRO software. If you are using iLink, see the iLink User's Manual. If
you are using CLARA and the Stack Storage software, see
Storage Setup" on page
The iLink PRO Storage software is used to create the initial material
layout in the iLink PRO software before creating the method. You
create the initial material layout in the iLink PRO Editor. The iLink
PRO User's Manual describes how to create a new method.
This section provides instructions for adding the materials to the
Twister II racks.
Adding Materials to the Twister II Racks in iLink PRO
When you create a new method in iLink PRO and the iLink PRO
Storage resource is added to the iLink PRO software, the graphic
below is displayed in the iLink PRO initial material layout.
P/N 113564 Rev. 2
The Stack Storage Configuration window displays a graphical
representation of the materials in the Twister II racks. If an
application returns a material to a storage rack, there will be one
empty rack per material type. Verify the configuration is correct
and click OK. If corrections are required, click Cancel to close
the configuration without saving and return to the main window.
be run consecutively, or chained, in CLARA.
Figure 12. iLink PRO Storage
Twister II Robot User's Manual
29.
Caliper Life Sciences, Inc.
Operation
35
"Stack
Advertisement
Table of Contents
