Table of Contents
Advertisement
Setting up a Storage Configuration (Continued)
9
10 Once the Stack Storage software has analyzed the CLARA
11 If necessary, edit the number in the Racks column to match the
12 Verify the Max Capacity column shows the actual number of
P/N 113564 Rev. 2
Click the OK button. The Stack Storage software begins
compiling the storage configuration. The Analyzing CLARA
window opens.
Figure 8. Analyzing CLARA Application Window
application, the Capacity Planning window opens (see
Figure
9). This window displays the number of racks in the
system and the maximum capacity of one rack for each material
in the method.
Figure 9. Capacity Planning Window
rack numbers in the system. Make sure the rack numbers match
the rack numbers that were taught in the Robot software.
Options are: 1 -3, 1- 6, or 1- 9.
materials that will fit in the rack when the rack is full (see
Figure
9). The default displayed by the software in the Max
Capacity column is an estimate based on the specifications of
the material. Make sure the specified number of materials
will fit in the rack without extending above the top of the
rack.
When using plates with lids (defined as two different materials
with different names but the same material type), count the
number of plates plus the number of lids. The total stack of
materials MUST be below the top of the rack.
Twister II Robot User's Manual
Operation
Caliper Life Sciences, Inc.
33
Advertisement
Table of Contents
