Table of Contents
Advertisement
Twister II - Maintenance
WARNING
•
•
•
Cleaning the Twister II
WARNING
Reagents used in processing activities with the Twister II may be
corrosive, radioactive, flammable, and/or toxic. Refer to the MSDS
(Material Safety Data Sheet) for detailed information.
•
•
•
•
The outside surfaces of the Twister II should be cleaned
periodically. Clean only the exterior of the unit. Never remove any
instrument covers to clean the inside of the instrument.
•
•
•
•
Clean the gripper and the racks with alcohol or other residue-free
solvent.
Wipe up any spills immediately.
Do not allow water or other fluids to drip inside the robot or pods.
P/N 113564 Rev. 2
Turn OFF the power and disconnect the power cord before
performing any procedure that requires removal of any panel or
cover, or disassembly of any interior instrument component.
Removal of protective covers marked with the High Voltage
warning symbol shown above can result in a safety hazard.
All maintenance procedures in this manual can be safely
performed by qualified personnel. Maintenance not covered in
this manual should be performed only by a Caliper
representative. See
Avoid direct contact with spilled liquid.
Wear protective gloves and safety glasses.
Dispose of liquid, containers, and tips properly.
Make sure that the waste container is large enough to hold all of
the waste generated.
Use a cloth or sponge dampened with water, alcohol, glass
cleaner, or a mild soap solution diluted with water.
If using glass cleaner or mild soap, wipe with a damp cloth or
sponge after cleaning to remove any residue.
Do not use abrasive cleaners.
Do not spray cleaner onto the instrument.
Twister II Robot User's Manual
Twister II - Maintenance 104
"Contact Us" on page
Caliper Life Sciences, Inc.
7.
Advertisement
Table of Contents
