Table of Contents
Advertisement
Communications Cable
The communications cable connects to the communications port on
the side of the Twister II pod or the back of the Assay Engine
Twister II and to a serial communications port on the computer.
Only one comm port on the computer is required for the Twister
Additional comm ports are required for additional instruments to the
system.
Power Cord
The power cord plugs into the Power Entry Port on the side of the
Twister II pod or the back of the Assay Engine Twister II. Input line
power of either 100/120V or 230/240V, 50 to 60 Hz, is required.
WARNING
•
•
•
P/N 113564 Rev. 2
Use a standard IEC 320-style power cord appropriate for your
country.
Verify the voltage stated on the power entry port matches the
voltage for your country. If the Twister II voltage setting is not
correct, change the fuse configuration (see
Twister II Fuse(s)" on page
Assay Engine Twister II does not need to be changed.
Only plug the power cord into a properly grounded outlet
supplying the correct voltage. Insert the three-pronged,
grounded plug fully.
Twister II Robot User's Manual
Twister II Hardware 103
"Changing the
105). The fuse configuration for the
Caliper Life Sciences, Inc.
II.
Advertisement
Table of Contents
