Table of Contents
Advertisement
Miscellaneous CO Parameters
Description
The Dial Pulse option lets the installer adjust the dial pulse ratio and
speed when using dial pulse (rotary) type signaling. By default, all lines
are DTMF (tone) signaling. If pulse dialing is required, the individual
outside line must be programmed for Dial Pulse (DP). When Dial Pulse is
selected, this system-wide parameter must be set to determine the
break/make ratio and the dial speed of the dial pulse signal.
DID Digits
Programming Steps
To make a change to the number of DID Digits:
1. Press the DID DIGITS flexible button (FLASH 41, Button #3). The
2. Enter a valid number (3–7) on the dial pad which corresponds to the
3. Press the HOLD button to save the entry. A confirmation tone is heard
Description
The DID Digits option allows the installer to adjust the amount of DID
Digits received from the CO. This amount is used by all DID trunks in the
system.
The DID Translation table can be programmed to determine the number
of digits used for the routing of a DID call. By default, the number of DID
digits is set to 3.
This program code is only used when an outside (CO) line is programmed
for Dial Pulse.
following message is shown on the display phone:
D ID D IG ITS
3
number of digits used for the routing of the DID Number.
and the display updates.
At least one DTMF receiver MUST be installed in the system
3- 7
3-39
Advertisement
Table of Contents
