Guard Timer - Vodavi STARPLUS Triad 1 System Programming Manual

3-34
2. Enter a valid number on the dial pad that corresponds to 000–255
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The Reseize Timer option lets the user adjust the Reseize Timer on a per
CO Line basis. The Reseize Timer can be used on any trunk type. This
timer sets the time period that a trunk is held disconnected after
receiving a disconnect before being reseized when a device is queued for
a member of the trunk group. By default, the Reseize Timer is set for two
seconds.

Guard Timer

Programming Steps
1. Press the GUARD TIMER button (FLASH 40, Page C, Button #6) in the
2. Enter a valid number on the dial pad which corresponds to 1–60
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The outgoing Guard Timer is used to set the length of time a CO is held
busy to outgoing seizure after a valid release is detected. If a user
attempts to access a CO line before the Guard Timer expires, their LED
illuminates to indicate that the line is seized, however the CO line is not
actually seized until the timer expires. The user gets a busy tone, and may
receive a delayed CO dial tone if the timer is set to a large value. By
default, the Guard Timer is set for .5 seconds.
(0 ms to 2.55 seconds).
display updates.
flexible button field. The following message displays:
G UAR D TIME R
05
(100 ms to 6 seconds).
display updates.
Page C Introduction
1-6 0