Table of Contents
Advertisement
12-48
Print DID-TIE Parameters
Programming Steps
1. Press the DID-TIE PARAMETERS flexible button (FLASH 85,
2. To print the DID-TIE Parameters, press the HOLD button. The
Description
The Print DID-TIE command dumps the entire database as a permanent
record which can serve as a hard copy of the database. The system baud
rate must match that of the printer or receiving device.
When printing the DID-TIE Timers, the following data is printed:
DID SIGNALING - WINK
DID DIGITS - 3
TIE SIGNALING - WINK
DID INC SIGNALING - DTMF
TIE INC SIGNALING - DTMF
T1 INC SIGNALING - DTMF
Button #14). The following message displays:
P R INT D ID / TIE TM RS
P R ESS H OLD
following message displays:
P R INT IN G D ID / TIE TMR S
When the system has finished sending the requested information to
the printer, confirmation tone is heard.
DID Parameters and Timers
TIE Line Parameters and Timers
Figure 12-15: DID-TIE Parameters Printout
Database Printing
Advertisement
Table of Contents
