Table of Contents
Advertisement
Programmable Flash Rates
Description
The In Use-Hold (I-Hold) flash rate is the rate at which a CO Line button or
Loop button flashes when a call is placed on In-Use Hold (I-Hold). This
flash rate can be programmed to 29 different options identified in the
flash rate table. This enables the programmer to customize the key
system configuration to desired flash rates. By default, In-Use Hold
(I-Hold) flash rate is set for a Green 60 ipm Flash (17).
Camp-On Button
Programming Steps
1. Press the CAMP-ON BTN flex button (FLASH 07, Button #15). The
2. Enter a valid number (00-28) on the dial pad to correspond to one of
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The Camp-On Button flash rate is the rate at which the Camp-On button
flashes when you receive a Camp-On. This flash rate can be programmed
to 29 different options identified in the flash rate table. This enables the
programmer to customize the key system configuration to desired flash
rates. By default, Camp-On Button flash rate is set for a Red 120 ipm
Flash (12).
following message displays:
CAM P ON BT N
R ED 1 20 IPM FLA SH
the 29 available options. (Refer to
display updates.
0 0-2 8
Table 2-6: Flash
Rates.)
2-55
Advertisement
Table of Contents
